cross-posted from: https://lemmy.dbzer0.com/post/6251091

I have this:

https://www.aquaplan.com/product/easy-band/

I need to attach it vertically to some thick hard rubber roofing. There is a small section of roof which should probably normally have a parapit but instead the roofing rubber is not backed by anything. Then below it is a wood panel. So when it rains sideways the water runs down the roofing rubber and behind the wood panel.

I just need a piece of shingle to divert water to the exterior side of the panel. Roofing glues are made to never cure. Probably rightfully so, but that probably wouldn’t work to attach a shingle vertically as gravity would over power that tar-like never fully dry stuff. I tried construction adhesive & it didn’t hold.

  • Masshuru@lemmy.world
    2·
    9 months ago

    For near-vertical mansard roof shingles, I think they use a combination of lots of nails and plastic cement.

    • diyrebel@lemmy.dbzer0.comOP
      1·
      9 months ago

      Thanks for the suggestion but in my case there is nothing to nail to. A shingle must be attached to thick (~2mm) rubber that’s just formed to be vertical. Perhaps I need to rivet the two rubber pieces together. Or I might try construction glue again but also get a couple metal plates and screws to clamp them together as a permanent clamp.