I’m launching a little balcony gardening project that involves water reservoirs. I don’t have much experience with these kinds of projects, so I need a little help.
Due to some dimensional constraints, I will need two regular plastic containers (your typical storage containers), and I was hoping to get away with only including a way to fill one of them. That means I will need to connect it to the other in some way. So I thought I would just drill a hole in both of them and stick a pipe between them.
- What is the best way to drill holes in plastic without risking any splitting?
- How do I make sure that the holes are water sealed afterwards? Can I glue around the pipe and plastic box?
Look up bulkhead fittings. Use them at work to connect chemical tanks together.
Ah, I was struggling to find the English term for that. Yeah, those are best, but you can improvise one with some threaded connections and some cut-out rubber (taken from an old bicycle interior tyre for example) or (not nearly as good) teflon tape.
This is what you’re looking for.
Cheers, I’ll look into those! :)