• Jentu@lemmy.film
    link
    fedilink
    English
    arrow-up
    0
    ·
    1 year ago

    Right slicer Settings as in “correct”? Is the intention of Benchy to float upright if your printer is tuned correctly?

    • EK13@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      I would say definitely not intended considering the linked page mentions very specific slicing but it’s cool nonetheless!

    • p1mrx@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      edit-2
      1 year ago

      Benchy was not designed to float. An STL file only defines the external geometry, but if you print it with default slicer settings, the density will be relatively constant throughout, and the resulting center of gravity is too high and too far forward to function as a boat.

      In order to make it float, I put more mass at the bottom/rear and less at the top.