![](/static/253f0d9b/assets/icons/icon-96x96.png)
![](https://lemmy.world/pictrs/image/e4083c7c-83c3-4258-8370-708e95e309b3.png)
I should have prefaced that I did not actually run this myself, but I did take a note of it, it looked promising. Sorry for the false hope!
I would expect it to work after a lot of fussing about, and then break at the slightest update. Easier to run it in a VM (which is also not easy in order to get GPU acceleration without dedicating a card to it - I never managed to get Intel GVT-g nor GVT-d to work reliably).
I was quite amazed reading NopHead’s blog a while back because he uses OpenSCAD exclusively, even managing to design an entire printer and its upgrades in there. I didn’t think any sane person could do this.